Hi *,
I have detected a strange behaviour when maintaining "some/special" marketing attributes for BP in logon language PL.
The affected attributes are configured as follows.
Format No. Chars Dec.Places Meas. unit Sing-val
Numeric Format 3 0 % X
The usage for EN/DE is fine but when trying to maintain a value like '30' using logon language PL the below mentioned error occurs. But obviously I don't use intervals etc. Just a single figure.
Attributes with the following settings do not lead to an issue:
Format No. Chars Dec.Places Meas. unit Sing-val
Numeric Format 10 0 X
DETAILS ON ERROR-MESSAGE
"
Diagnosis
Possible causes:
Intervals can only be specified if you have set the indicator Intervals
Allowed.
- You must specify the interval in the form value 1 - value 2 (there must be a
space both before and after the hyphen). No other character except a hyphen may
be used to separate the values.
- A value can contain up to the same number of decimal places as specified in
the Decimal Places field.
- The value in the field Number of Chars defines the total number of
characters, including decimal places (for example: If the number of characters =
3, and the number of decimal places = 1, then 20.1 is valid, but 300.1 is not
valid).
- You must define the decimal point and the thousand separator according to
your user settings.
Procedure
Use the value help, if available, to select a permitted
value. If there is no value help available, check the data type of the marketing
attribute."
To exclude the possibilty the attribute could be "damaged" I created a new one with same options and got the same language dependend behaviour.
Any ideas?
Kind regards
Thomas